AKOM Technologies Private Limited
AKOM Technologies Private Limited
Opposite Apollo Hospital, New Delhi, Delhi
SEND SMS
SEND EMAIL

OpenVox PRI Card

Prominent & Leading Manufacturer from New Delhi, we offer openvox 1 port pri card, openvox 2 port pri card and openvox 4 port pri card.

OpenVox 1 Port PRI Card

OpenVox 1 Port PRI Card
  • OpenVox 1 Port PRI Card
Get Best Quote
Approx. Price: Rs 22,000 / per pieceGet Latest Price

Product Details:

No. Of Ports1
Support OSLinux
BrandOpenVox

OpenVox D130 Series is now the leading single port T1/E1/J1 PCI-E card in the open source industry. It supports up to 32 channels in E1 mode or 24 channels in T1/J1 modes. It takes full advantage of Octasic® Hardware Echo Cancellation Module to deliver the superior voice quality over T1, E1, and J1 interface.

The D130 Series is an upgrade product of the D115 Series. It’s supposed to be the most advanced single port T1/E1/J1 asterisk® card with superior quality in the open source community. It supports T1, E1, and J1 environments and is selectable on a per-card or per-port basis. The leading innovation ensures users to adjust the interrupts frequency to reduce the CPU load up to 70% and adjust the interrupt number to avoid interrupt number sharing or conflict.

DE130 Series offers an on-board Octasic® DSP-based echo cancellation module. The Octasic® DSP-based EC module enables users to eliminate echo tails up to 128ms or 1024 taps across all 32 channels in E1 mode or 24 channels in T1/J1 modes. Further, this module takes advantage of the Octasic® Voice Quality Enhancement to provide superior sound quality on all calls.

D130 Series supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported.

D130 Series works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications

Target Applications

  • Voice-over Internet Protocol (VoIP) Services
  • Complex IVR Trees
  • "Meet-Me" Bridge Conferencing
  • Calling Card Platforms
  • VoIP Gateways (support SIP, H.323, and IAX)
  • Legacy PBX/IVR Services
  • Voice/Data Router (replace expensive routers)
  • PRI/Switch Compatibility - Network or CPE

Optional Octasic® DSP Echo Cancellation Module--EC2032

  • 128ms tail/channel (on all channel densities)
  • Octasic® Music Protection
  • Adaptive Noise Reduction
  • Automatic Level Control (G.169)
  • Field upgradeable algorithm
  • V.25 / V.8 answer tone (w/ and w/o phase reversal)
  • DTMF as per Q.24
  • No CPU load as a result of echo cancellation.
  • Does not increase the physical size of the card, and no additional slot is required
  • EC2032 power: 3.83W
  • Storage temperature: -40°C to 75°C

Operating Systems

  • Linux (all versions, releases and distributions from 1.0 up)

Certifications

  • RoHS compliant
  • Certificates: FCC, CE and CS-03

Technical Specifications

  • Single T1/E1/J1 ports with PCI interface for high performance voice and data applications
  • RJ48 connector
  • Low profile option
  • FPGA design, upgradeable firmware onsite

Minimum Hardware Requirement

  • 800-Mhz Pentium III
  • 128MB RAM

PRI Switch Compatibility

  • EuroISDN (PRI or PRA) - Q.931/Q.921
  • Network or CPE
  • AT&T 4ESS
  • National ISDN 2
  • CAS Voice Modes
  • DMS 100
  • Lucent 5E

Operating Systems

  • Linux (all versions, releases and distributions from 1.0 up)
01 Month "NO Question Asked" Return Policy
Request
Callback


Additional Information:

  • Item Code: D130E
  • Port of Dispatch: New Delhi
Send Bulk Enquiry
View PDF

Openvox 2 Port PRI Card

Openvox 2 Port PRI Card
  • Openvox 2 Port PRI Card
Ask For Price
Product Price :Get Latest Price

Product Details:

No. Of Ports02 Port
Support OSLinux
BrandOpenVox

Specifications

OpenVox D230 Series is now the leading 2 port T1/E1/J1 PCI-E card in the open source industry. It takes full advantage of Octasic® Hardware Echo Cancellation Module to deliver the superior voice quality over T1, E1, and J1 interface.

D230 Series is an upgrade product of the D210 Series. It’s supposed to be the most advanced 2 port T1/E1/J1 asterisk® card with superior quality in the open source community. The leading innovation ensures users to adjust the interrupts frequency to reduce the CPU load up to 70% and adjust the interrupt number to avoid interrupt number sharing or conflict.

D230 Series offers an on-board Octasic® DSP-based echo cancellation module. It supports T1, E1, and J1 environments and is selectable on a per-card or per-port basis. The Octasic® DSP-based EC module enables users to eliminate echo tails up to 128ms or 1024 taps across all 64 channels in E1 mode or 48 channels in T1/J1 modes. Further, this module takes advantage of the Octasic® Voice Quality Enhancement to provide superior sound quality on all calls.

D230 Series supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported.

D230 Series works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications.

Target Applications

  • Voice-over Internet Protocol (VoIP) Services
  • Complex IVR Trees
  • "Meet-Me" Bridge Conferencing
  • Calling Card Platforms
  • VoIP Gateways (support SIP, H.323, and IAX)
  • Legacy PBX/IVR Services
  • Voice/Data Router (replace expensive routers)
  • PRI/Switch Compatibility - Network or CPE

Minimum Hardware Requirement

  • 800-Mhz Pentium III
  • 128MB RAM

Operating Systems

  • Linux (all versions, releases and distributions f rom 1.0 up)

Technical Specifications

  • 2 T1/E1/J1 ports with PCI interface for high performance voice and data applications
  • RJ48 connector
  • FPGA design, upgradeable firmware onsite
  • Power: 2.3W Minimum, 3.5W Maximum at 3.3 V or 5 V.
  • Operation temperature: 0°C to 50°C
  • Dimension: 2U Form factor: 12*6.4*1.8cm

Optional Octasic® DSP Echo Cancellation Module—EC2064

  • 128ms tail/channel (on all channel densities)
  • Octasic® Music Protection
  • Adaptive Noise Reduction
  • Automatic Level Control (G.169)
  • Field upgradeable algorithm
  • V.25 / V.8 answer tone (w/ and w/o phase reversal)
  • DTMF as per Q.24
  • No CPU load as a result of echo cancellation.
  • Does not increase the physical size of the card, and no additional slot is required
  • EC2064 power: 0.33W/3.5W
  • Storage temperature: -40°C to 75°C

PRI Switch Compatibility

  • EuroISDN (PRI or PRA) - Q.931/Q.921
  • Network or CPE
  • AT&T 4ESS
  • National ISDN 2
  • CAS Voice Modes
  • DMS 100
  • Lucent 5E

Certifications

  • RoHS Compliant
  • Certificates: FCC, CE and CS-03


01 Month "NO Question Asked" Return Policy

Request
Callback


Additional Information:

  • Item Code: D230E
  • Port of Dispatch: New Delhi
Send Bulk Enquiry
View PDF

Openvox 4 Port PRI Card

Openvox 4 Port PRI Card
  • Openvox 4 Port PRI Card
Ask For Price
Product Price :Get Latest Price

Product Details:

No. Of Ports4 Ports
Support OSLinux
BrandOpenVox

OpenVox D430 Series is now the leading 4 port T1/E1/J1 PCI-E card in the open source industry. It takes full advantage of Octasic® Hardware Echo Cancellation Module to deliver the superior voice quality over T1, E1, and J1 interface.

The D430 Series is an upgrade product of the D410 Series. It’s supposed to be the most advanced 4 port T1/E1/J1 asterisk® card with superior quality in the open source community. The leading innovation ensures users to adjust the interrupts frequency to reduce the CPU load up to 70% and adjust the interrupt number to avoid interrupt number sharing or conflict.

D430 Series offers an on-board Octasic® DSP-based echo cancellation module. It supports T1, E1, and J1 environments and is selectable on a per-card or per-port basis. The Octasic® DSP-based EC module enables users to eliminate echo tails up to 128ms or 1024 taps across all 128 channels in E1 mode or 96 channels in T1/J1 modes. Further, this module takes advantage of the Octasic® Voice Quality Enhancement to provide superior sound quality on all calls.

D430 Series supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported.

D430 Series works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications.

Target Applications

  • Voice-over Internet Protocol (VoIP) Services
  • Complex IVR Trees
  • "Meet-Me" Bridge Conferencing
  • Calling Card Platforms
  • VoIP Gateways (support SIP, H.323, and IAX)
  • Legacy PBX/IVR Services
  • Voice/Data Router (replace expensive routers)
  • PRI/Switch Compatibility - Network or CPE

Technical Specifications

  • 4 T1/E1/J1 ports with PCI interface for high performance voice and data applications
  • RJ48 connector
  • FPGA design, upgradeable firmware onsite
  • Power: 2.6W Minimum, 3.9W Maximum at 3.3 V or 5 V.
  • Operation temperature: 0°C to 50°C
  • Dimension: 2U Form factor: 12*6.4*1.8cm

Minimum Hardware Requirement

  • 800-Mhz Pentium III
  • 128MB RAM

Certifications

  • RoHS Compliant
  • Certificates: FCC, CE and CS-03

PRI Switch Compatibility

  • EuroISDN (PRI or PRA) - Q.931/Q.921
  • Network or CPE
  • AT&T 4ESS
  • National ISDN 2
  • CAS Voice Modes
  • DMS 100
  • Lucent 5E

Optional Octasic® DSP Echo Cancellation Module—EC2128

  • 128ms tail/channel (on all channel densities)
  • Octasic® Music Protection
  • Adaptive Noise Reduction
  • Automatic Level Control (G.169)
  • Field upgradeable algorithm
  • V.25 / V.8 answer tone (w/ and w/o phase reversal)
  • DTMF as per Q.24
  • No CPU load as a result of echo cancellation.
  • Does not increase the physical size of the card, and no additional slot is required
  • EC2128 power: 0.33W/3.5W
  • Operation temperature: 0 to 50°C



01 Month "NO Question Asked" Return Policy

Request
Callback


Additional Information:

  • Item Code: D430E
  • Port of Dispatch: New Delhi
Send Bulk Enquiry
View PDF
X

Explore more products

VOLTE GSM Gateway
VOLTE GSM Gateway
Get Best Quote
A400 Series
A400 Series
Get Best Quote
IPPBX
IPPBX
Get Best Quote
FWP-RANGER
FWP-RANGER
Get Best Quote


Reach Us
Arun Kumar (Business Head)
227, U.S. Complex, Mathura Road
Opposite Apollo Hospital, New Delhi- 110076, Delhi, India



Call Us

Share Us

F GT L


Send E-mailSend SMS